EchoStar Over-the-Air Module MT2 User's Guide download pdf (Page 4)

Page 3

• These instructions assume you have an over-the-air antenna

suitable for your area already installed in your system. Refer to

www.antennaweb.org

or a local retailer for assistance in choosing

and peaking an over-the-air antenna.

Installing the MT2 Module

1. Unplug the receiver’s power cord from the electrical outlet.

Unplug the receiver’s power cord from electricity anytime you

install or remove the OTA module. Doing so reduces the

danger of electrical shock, which could damage the module

and the receiver, and injure or kill you.

2. Look at the back panel of your satellite receiver, and locate the

cover on the left side of the back panel. Remove the two screws

attaching the cover to the receiver (see Figure 1). Keep the screws

for use in installing the module.

Figure 1. Removing the Cover

OTA Module.book Page 3 Thursday, July 3, 2008 4:35 PM

1 2 3 4 5 6 7 8 9 ... 17 18

No comments

EchoStar Over-the-Air Module MT2 User's Guide Page 4