EchoStar 9630 Troubleshooting Guide download pdf (Page 10)

1. Turn TV and satellite receiver on.

2. Go to the signal meter screen on TV.

Choose transponder number: Dish Network #11

DIRECTV #19

3. Enter local zip code on signal meter screen to determine satellite

elevation. If you do not know your local zip code, determine your

elevation from the elevation maps in the Reference Section.

4. Press UP arrow on King-Dome Controller to turn King-Dome on.

5. Press UP or DOWN arrow on King-Dome Controller to display dish

elevation and match to elevation on TV signal meter screen or

elevation from the elevation maps in the Reference Section.

6. Press and hold RIGHT arrow until Controller begins flashing “77.”

Remember, you must watch for signal strength on TV!

Dish will automatically perform a 360 degree scan for satellite.

When signal strength appears on TV, momentarily press

ANY BUTTON to stop the dish from rotating.

7. Press the UP, DOWN, LEFT or RIGHT arrows to fine tune signal

strength to the highest possible number on TV signal meter

screen. Enjoy your programming!

Controller automatically shuts off after 2 minutes.

Page 8

PART ONE: Serial Number 169999 and lower

Basic Operation

Note: The King-Dome Controller will count down from 99 to 00

and then display OH.

IMPORTANT! In Step 6, as soon as you begin holding the right

arrow, you must continuously monitor the TV

signal meter screen until signal appears on TV.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 99 100

No comments

EchoStar 9630 Troubleshooting Guide Page 10